JLG 1350SJP Service Manual - Manual (Page 266)

SECTION 4 - BOOM & PLATFORM
4-32 – JLG Lift – 3121142
10. Apply JLG Threadlocker P/N 0100011 to the bolts and
install the rear upper and side wear pads on the outer
mid boom section as marked during disassembly.
Torque the bolts to 50 ft.lbs. (68 Nm).
11. Uncoil the fly retract wire ropes from the fly boom.
Route the threaded ends of the wire ropes through the
holes in the outer mid boom plates at the retract sheave
locations.
12. Apply a thin coat of moly paste lubricant to the inside
diameter of the sheave composite bearings. Install the
fly retract sheaves and bushings while guiding the wire
ropes into the sheave grooves. Apply moly paste lubri-
cant on the inside diameter of the sheave bushing cup.
Ensure the sheaves move freely. Apply JLG Threadlocker
P/N 0100019 to the sheave retaining bolts and torque to
165 ft.lbs. (224 Nm). Install the cable retract retainer
plates and cable retainer blocks.
13. Apply JLG Threadlocker P/N 0100011 to the bolts and
install the lower rear wear pad onto the outer mid boom
section. Torque the bolts to 50 ft.lbs. (68 Nm).
14. Apply JLG Threadlocker P/N 0100011 to the bolts and
install the side and upper wear pads on the rear of the
inner mid boom section. Torque the bolts to 50 ft.lbs. (68
Nm).
15. Lubricate the wear surfaces on the inside of the inner
mid boom section with Super Lube.