JLG 1350SJP Service Manual User Manual

Page 481

Advertising
background image

SECTION 6 - JLG CONTROL SYSTEM

3121142

– JLG Lift –

6-105

8634

86

34

REAR RIGHT STEER SENSOR - SHORT TO GROUND OR OPEN CIRCUIT

There is a Short to Ground or an
Open Circuit to the Rear Right
Steer Sensor.

8635

86

35

REAR RIGHT STEER SENSOR - SHORT TO BATTERY

There is a Short to Battery to the
Rear Right Steer Sensor.

8636

86

36

REAR LEFT STEER SENSOR - SHORT TO GROUND OR OPEN CIRCUIT

There is a Short to Ground or an
Open Circuit to the Rear Left
Steer Sensor.

8637

86

37

REAR LEFT STEER SENSOR - SHORT TO BATTERY

There is a Short to Battery to the
Rear Left Steer Sensor.

8651

86

51

ENGINE SHUTDOWN - AXLE LOCKOUT VALVE FAULT

Engine Start is prevented while
there is an Oscillating Axle fault
and vehicle is out of transport
position

990

99

0

<<< HARDWARE >>>

998

99

8

EEPROM FAILURE - CHECK ALL SETTINGS

The Ground Module has
reported an EEPROM failure.

9910

99

10

FUNCTIONS LOCKED OUT - PLATFORM MODULE SOFTWARE VERSION
IMPROPER

The Platform Module software
version is not compatible with
the rest of the system.

9914

99

14

PLATFORM MODULE SOFTWARE UPDATE REQUIRED

The Platform Module software
requires an updated.

9915

99

15

CHASSIS TILT SENSOR NOT GAIN CALIBRATED

The Chassis Tilt Sensor gain cali-
bration has been lost.

9916

99

16

CHASSIS TILT SENSOR GAIN OUT OF RANGE

The Chassis Tilt Sensor gain cali-
bration has become corrupted.

9917

99

17

HIGH RESOLUTION A2D FAILURE - INTERRUPT LOST

The Platform Module has
reported that its ADS1213 chip
has stopped asserting its inter-
rupt.

9918

99

18

HIGH RESOLUTION A2D FAILURE - REINIT LIMIT

The Platform Module has
reported that its ADS1213 chip
had to be reset 3 or more times.

9919

99

19

GROUND SENSOR REF VOLTAGE OUT OF RANGE

The Ground Module has
reported that its sensor refer-
ence voltage is outside accept-
able range.

- Not reported during power-up.

9920

99

20

PLATFORM SENSOR REF VOLTAGE OUT OF RANGE

The Platform Module has
reported that its sensor refer-
ence voltage is outside accept-
able range.

- Not reported during power-up.

Table 6-6. Diagnostic Trouble Code Chart

DTC

Flash

Code

Sequence

Fault Message

Fault Description

Check

Advertising
This manual is related to the following products: