JLG 1350SJP Service Manual User Manual
Page 413
SECTION 6 - JLG CONTROL SYSTEM
3121142
– JLG Lift –
6-37
BOOM:
U LIFT
UP/DOWN XXX%
Displays main lift joystick direction & demand
SWING
RIGHT/LEFT XXX%
Displays swing joystick direction & demand
QPRX1
ACTIVE/NOT ACTIVE
Displays status of Q-Prox sensor in lift/swing joystick (Displayed if JOYSTICK
TYPE = 1)
QPRX2
ACTIVE/NOT ACTIVE
Displays status of Q-Prox sensor in lift/swing joystick (Displayed if JOYSTICK
TYPE = 1)
LEVEL
UP/DOWN XXX%
Displays basket level switch direction & demand. NOTE: demand is controlled
by the pump pot
ROT.
RIGHT/LEFT XXX%
Displays basket rotate switch direction & demand. NOTE: demand is con-
trolled by the pump pot
U TELE
IN/OUT XXX%
Displays main telescope switch direction & demand. NOTE: demand is con-
trolled by the pump pot
T TELE
IN/OUT XXX%
Displays tower telescope switch direction & demand. NOTE: demand is con-
trolled by the pump pot
Not displayed if TOWER TELE=NO (machine digit = 0)
T LIFT
UP/DOWN XXX%
Displays tower lift switch direction & demand. NOTE: demand is controlled by
the pump pot
Not displayed if TOWER LIFT=NO (machine digit = 0)
JIB
UP/DOWN XXX%
Displays jib lift switch direction & demand. NOTE: demand is controlled by the
pump pot
Not displayed if JIB = NO (machine digit = 0)
JIB
RIGHT/LEFT XXX%
Displays jib swing switch direction & demand. NOTE: demand is controlled by
the pump pot
Displayed if JIB = SIDESWING (machine digit = 2)
JIB INLINE
OP/CL
Displays status of jib inline limit switch. Displayed on models equipped with
the Jib Stow System
JIB LIMIT
OP/CL
Displays status of jib right limit switch. Displayed on models equipped with
the Jib Stow System
JIB LIM OVRD
OP/CL
Displays status of jib limit override switch. Displayed on models equipped
with the Jib Stow System
PCV
ON/OFF
Displays status of Platform Control Valve. Displayed on models equipped with
Electronic Platform Leveling.
PUMP POT
XXX%
Displays pump pot demand. Not displayed if MODEL = 601 (machine digit =
4)
CREEP
ACTIVE/NOT ACTIVE
Displays pump pot creep switch status
CRP MODE
ACTIVE/NOT ACT
Displays creep mode status
Table 6-5. Machine Diagnostics Parameters
Diagnostics Submenu
(Displayed on Analyzer
1
st
Line)
Parameter (Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description