JLG 1350SJP Service Manual - Manual (Page 86)

SECTION 3 - CHASSIS & TURNTABLE
3-40 – JLG Lift – 3121142
25. Assemble the O-ring seal (2) into its seat in the end
cover (7).
26. Protect the seat and the pin (3) with grease type
MOLYKOTE G6000. Wait 15 minutes for it to completely
dry. Insert the pin (3) in its seat in the end cover (7).
27. Assemble the cap nut (5).
28. Torque the 2 screws M8x16 (4) grade 8.8, to 18.4 ft.lbs.
(25 Nm).
29. Insert the 1st washer (12) in the splined shaft (14).
30. Insert the spring (13) in the splined shaft (14).