JLG 1350SJP Service Manual - Manual (Page 262)

SECTION 4 - BOOM & PLATFORM
4-28 – JLG Lift – 3121142
TAKE EXTRA CARE NOT TO CROSS ANY WIRE ROPES DURING THE ASSEMBLY
PROCEDURE.
1. Install the fly extend wire rope button ends into the slots
on the bottom of the fly boom section. Place tape over
the wire ends to keep them in place during assembly.
2. Fabricate a special fixture as shown below to keep four
extend wire ropes from crossing over each other.
3. Install the fly retract wire rope button ends into the slots
in the side of the fly boom, coil the remaining lengths of
wire rope and place them into the fly boom, tape the
slots to keep the rope from jumping out.