JLG 1350SJP Service Manual - Manual (Page 83)

SECTION 3 - CHASSIS & TURNTABLE
3121142 – JLG Lift – 3-37
9. By using a press and a metallic stopper, push the gear-
box housing (23) against the shoulder on the flanged
hub (31) until assembling of the unit is complete.
SCREW THE NUT (22) ON PARTIALLY IN ORDER TO PREVENT THE FLANGED
HUB (31) FROM COMING OUT OF THE GEARBOX HOUSING (23) DURING THE
FOLLOWING STEPS.
10. By using a hoist place the torque multiplier
(ATZ.09.016.0) on the ring nut (22).
11. By using the mutiplier (ATZ.09.016.0), tighten the ring
nut (22), using a torque wrench with an input multiplier
torque of 71 ± 3 ft.lbs.(96,5 ± 4, 5 Nm) corresponding to
an output multiplier torque of 3688 ± 184 ft.lbs. (5000 ±
250 Nm).
12. Stake the ring nut (22) near 2 seats at 180° of the flanged
hub (31) on the right side.
NOTE: Stake Ø 4+5 mm (depth 1+1,5 mm).