JLG 1350SJP Service Manual - Manual (Page 261)

SECTION 4 - BOOM & PLATFORM
3121142 – JLG Lift – 4-27
46. Remove the tape from the fly boom section and remove
the fly boom retract cables.
47. Remove the fly boom extend cables from the bottom of
the fly boom section.
48. Thoroughly clean the boom sections.
Assembly
NEVER HANDLE WIRE ROPE WITH BARE HANDS.
NOTE: Moderately apply Super Lube JLG Part No. 3020042 to all
four inner surfaces of both ends of each boom section to a
minimum depth of 3 to 4 feet (1 to 1.25 m). The fly boom
section only needs Super Lube applied to the insertion end.
Super Lube is also to be moderately applied to all outer sur-
faces of interior wear pads after they are installed to the
insertion end of boom sections. Care should be taken to
avoid application on exposed painted surfaces of the fully
extended boom. Refer to Section 4.3 - Boom Lubrication
Application.
WIRE ROPE NUTS ARE CLOSE IN SIZE AND CAN BE SWITCHED. REFER TO THE
JLG PARTS MANUAL. OUTER MID RETRACT NUTS, LOCATED ON BOTTOM OF
BASE BOOM, WILL BE BLACK IN COLOR.