JLG 1350SJP Service Manual - Manual (Page 290)

SECTION 4 - BOOM & PLATFORM
4-56 – JLG Lift – 3121142
4. Hold the flat bar and remove the screws.
5. Remove the snap rings and pins.
6. Remove the screws from the bar. Remove the snap ring
and pin.
7. Slide the link out.
Snap Rings and Screws
WHEN PERFORMING MAINTENANCE ON THE POWERTRACK, MAKE SURE TO
DISCARD AND REPLACE ALL OLD SCREWS.
Make sure screws are tight and installed properly.
LOOSE SCREW TIGHT SCREW