JLG 1350SJP Service Manual - Manual (Page 391)

SECTION 6 - JLG CONTROL SYSTEM
3121142 – JLG Lift – 6-15
When a top level menu is selected, a new set of menu items
may be offered: for example:
DRIVE
BOOM
SYSTEM
DATALOG
VERSIONS
Pressing ENTER with any of the above displayed menus, will
display additional sub-menus within the selected menu. In
some cases, such as DRIVE, the next level is the parameter or
information to be changed. Refer to the flow chart for what
menus are available within the top level menus. You may only
view the personality settings for selected menus while in
access level 2. Remember, you may always cancel a selected
menu item by pressing the ESC. key.
6.6 CHANGING THE ACCESS LEVEL OF THE HAND
HELD ANALYZER
When the analyzer is first connected, you will be in access level
2 which enables you to only view most settings which cannot
be changed until you enter a password to advance to a lower
level. This ensures that a setting cannot be accidentally
altered. To change the access level, the correct password must
be entered. To enter the password, scroll to the ACCESS LEVEL
menu. For example:
MENU:
ACCESS LEVEL 2
Press ENTER to select the ACCESS LEVEL menu.
Using the UP or DOWN arrow keys, enter the first digit of the
password, 3.
Then using the RIGHT arrow key, position the cursor to the
right one space to enter the second digit of the password.
Use the UP or DOWN arrow key to enter the second digit of
the password which is 33271.
Continue using the arrow keys until all the remaining digits of
the password is shown.
Once the correct password is displayed, press ENTER. The
access level should display the following, if the password was
entered correctly:
MENU:
ACCESS LEVEL 1
Repeat the above steps if the correct access level is not dis-
played or you can not adjust the personality settings.