Lenze E94AYCEC - Manual (Page 77)

Lenze · E94AYCEC Communication module (POWERLINK CN) · Communication Manual · DMS 3.0 EN · 08/2014 · TD17
77
10 Parameter reference
10.2 Parameters of the communication module for slot MXI1
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C13132
C13136
C13219
Parameter | Name:
C13132 | EPL CN: Link interruptions
Data type: UNSIGNED_32
Index: 11443 = 0x2CB3
EPL index: 0x1C10
The code indicates the counter of the Controlled Node for POWERLINK connection interruptions.
Each event is counted. Every single event is followed by an error message. No threshold value management is
implemented.
Display area
(min. value | unit | max. value)
0 4294967295
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13136 | EPL telegram counter
Data type: UNSIGNED_32
Index: 11439 = 0x2CAF
EPL index: 0x1101.0x01
The subcodes of the code indicate a counter for EPL cycles. The counter is started with each mains power-up of the
EPL node at 0. An overflow occurs at 4.294.967.295.
Display area
(min. value | unit | max. value)
0 4294967295
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C13219 | EPL device type MN
Data type: UNSIGNED_32
Index: 11356 = 0x2C5C
EPL index: See subcodes
The code contains the device type ID of the EPL nodes. Each subcode corresponds to an EPL node with node ID =
subcode number.
When being in the configured status, the values must be identical with the device types stored locally in each EPL
node under C13030 .
Subcodes Lenze setting Info EPL index
C13219/1 0 Managing node 0x1F84.0xF0
C13219/2 0 Diagnostics device 0x1F84.0xFD
C13219/3 0 router 0x1F84.0xFE
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT