Rockwell Automation 1756-RIO ControlLogix Remote I/O Communication Interface Module User Manual - Manual (Page 20)

20 Publication 1756-UM534B-EN-P - November 2010
Chapter 1 The 1756-RIO Module-Getting Started
To install the add-on profile along with the configuration tool, follow these
steps.
1. Make sure any instances of RSLogix 5000 programming software is shut
down before beginning.
2. Insert the CD that was shipped with your module into your computer.
3. Open the folder 1756-RIO Configuration Tool Setup. Run the
MPSetup.exe program.
The RSLogix 5000 Module Profiles Setup Wizard launches.
4. Follow the prompts to complete the installation. Click Next. Accept the
License Agreement, install the profile, and begin.
ATTENTION
If you get a message about DTL32.DLL when installing or
running the programs on the configuration CD, it indicates
problems with the RSLinx software installation. Confirm that
you have the correct version of RSLinx software. RSLinx Lite
software cannot be used.