Rockwell Automation 1756-RIO ControlLogix Remote I/O Communication Interface Module User Manual - Manual (Page 63)

Publication 1756-UM534B-EN-P - November 2010 63
Configure Adapter Mode Chapter 3
Set the Baud Rate To set the baud rate in adapter mode, follow these steps.
1. On the 56RioCfgAdpt dialog box, right-click on the controller on the I/
O tree and from the pull-down menu, select 1756-RIO Properties.
The 1756-RIO Properties dialog box displays.
2. On the 1756-RIO Module Properties dialog box, select the baud rate.
3. You can also enter an LED Banner name. This is a unique name you
assign to identify the module. This is useful when you have multiple
RIO modules on your network. The LED Banner displays on the 4-
character display on the 1756-RIO module. It can be from 0…15
characters long.
4. Click OK.
The default baud rate is Auto (automatic baud rate detection).
Value Baud Rate, Kbps
57 k 57.6
115 k 115.2
230 k 230.4
Auto - adapter mode default Auto
TIP
If you perform an autoconfiguration, the 1756-RIO module
automatically detects the baud rate by monitoring an attached
Remote I/O network.
TIP
If you are only using Active racks, set the baud rate to match
the Remote I/O network. Don’t set it to Auto.