Clear mappings – Rockwell Automation 1756-RIO ControlLogix Remote I/O Communication Interface Module User Manual User Manual
Page 57
Advertising
Publication 1756-UM534B-EN-P - November 2010
57
Configure Scanner Mode Chapter 2
Clear Mappings
Follow these steps to clear all mappings.
1. To clear all assigned mappings, on the 56RioCfgScan dialog box, from
the Map menu, choose Clear All Mappings.
2. On the Clear ALL Mappings dialog box, confirm that you want to clear
all the existing mappings and click Yes.
IMPORTANT
If you change mappings, make sure you clear the output table in
the ControlLogix controller to prevent inadvertently writing to
an incorrect I/O location. If you leave a value behind in the
output table, it now points to something else on the Remote I/O
network. To clear the output table, set the outputs to 0. You
must also re-import the aliases.
Advertising