Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 119)

Chapter 8
Debugging Your DDMC32 System
8-9
Input History for a Transfer Line Station (SDS Instruction)
Input History for STATION 7R
accumulated time duration input state address
00:00:00.53 00:00:00.53 2 1 I:006/01
00:00:01.81 00:00:01.28 2 0 I:006/01
00:00:02.04 00:00:00.23 3 1 I:006/02
00:00:03.03 00:00:00.99 3 0 I:006/02
00:00:03.05 00:00:00.02 9 1 I:001/04
00:00:03.75 00:00:00.70 9 0 I:001/04
00:00:03.99 00:00:00.24 1 1 I:006/00
00:00:07.03 00:00:03.04 1 0 I:006/00
Press a key for desired histogram function.
RUN Hist:Started Mode:Paged Disk Recording Off Current Step:13
Start Stop Contin Paged Input Write
History History Mode Mode Trigger To Disk
F1 F2 F3 F4 F5 F8
You can perform the following tasks from the Input History screen:
If you want to: Press this key:
Begin monitoring the current instruction. [F1] - Start History
Stop monitoring the current instruction. [F2] - Stop History
Display data continuously on the screen as new
data is collected. If new data is generated faster
that the display can be updated, eventually the data
buffers overflow and “Data Overrun” is displayed. [F3] - Contin Mode
Display data one page at a time. Press Next Page
or Previous Page to scroll through the data. [F4] - Paged Mode
Specify a starting point at which to activate the timer
and display. When the SDS instruction is looking at
a specified input, the timer is waiting for a transition.
When this occurs, the timer is set to zero and the
display screen is activated, logging all inputs from
that point on. [F5] - Input Trigger
Store the input history on disk. [F8] - Write to Disk