Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 46)

Configuring SDS Instructions
Chapter 4
4-10
6. Type SDS, if it does not already appear at the prompt, and press [ENTER] .
(If you are modifying an existing instruction, SDS already appears at the
prompt.)
As an alternate method of entering the instruction, you may:
Press [F10] - Others
Press [F9] - Seqncer from the Instruction Classes function keys
Press [F6] - SDS from the Shift Sequencer function keys
The system displays the SDS instruction, seen below.
SDS Instruction (PLC-5)
| +SDS–––––––––––––––––––––––––+ |
+––––––––––––––––––––––––––––––––––––––––––+SMART DIRECTED SEQUENCER +–(EN)–+
| |Control File | |
| |Step Desc. File +–(ST) |
| |Length | |
| |No. of Steps +–(ER) |
| |Position/Step: | |
| |No. of I/O +–(ES) |
| |Program File No. | |
| +––––––––––––––––––––––––––––+ |
| |
+––––––––––––––––––––––––––––––––[END OF FILE]–––––––––––––––––––––––––––––––––+
| |
Enter the operand.
Enter the Control File address>
Program Forces:Disabled Edits:None PLC–5/25 Addr 5