Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 83)

Chapter 5
Configuring DFA Instructions
5-9
Enter or Modify Input Information
The inputs you enter into the Input Defines on the Input Definition screen
are monitored by the DFA instruction. You can enter logical addresses and
symbols into the Input Definition screen. The screen on the next page
shows the Input Definition Screen for entering inputs.
Important: If you are modifying information, you see fewer function key
options (see the table on pages 5-9 and 5-10).
Input Definition Screen (for entering inputs)
Diagnostic Fault Annunciator Input Defines
Definition for Control Block 0:
N27:0 1: I:001/10
2: SWITCH1
3: B3/30
+=Ins Cmt==+ +=Adr Cmt==+ 4: 0:002/02
|ASSEMBLY | |new input | 5: 0:002:01
|MACHINE | | | 6: I:001/11
| | | | 7:
| | | | 8:
| | | | 9:
+==========+ +==========+ 10:
11:
Operator Interface Station Addr : 77 12:
13:
14:
15:
Press a key to change a parameter or <ENTER> to accept parameters,
>
Program Forces: None Edits: None PLC–5/25 Addr 5
Station Documnt Modify Insert Delete Remove
Address Inputs Inputs Inputs Inputs
F1 F5 F7 F8 F9 F10
The Ins Cmt (Instruction Comment) window on the Input Definition
screen displays the name of the instruction from the ladder program. The
Adr Cmt (Address Comment) window displays the address comment for
the cursored address in the Input Defines field.
The number of inputs in the Input Defines field correlates with the number
of inputs you entered when programming the DFA instruction.
You can perform the following tasks from the Input Definition screen:
If you want to: Press this key:
Enter an operator interface station address. [F1] - Station Address
Enter the port number for the message.
PLC-5/250 only) [F3] - Port