Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 52)

Configuring SDS Instructions
Chapter 4
4-16
To insert or modify information in the I/O Definition screen, follow the
procedure below.
1. If you want to change the Operator Interface Station Address:
a. Press [F1] - Station Address.
b. Type the number of the Data Highway Plus node ( 0-77) where you
want the diagnostic messages sent, for example
77 , and press
[ENTER].
Important: If you want to send diagnostic messages to other operator
interface stations, use the Message Instruction in 6200 Series software.
For procedures on sending messages with the Message Instruction, refer to
PLC-5 Programming Software Documentation Set (publication
6200-N8.001) or the PLC-5/250 Programming Software Documentation
Set (publication 6200-N8.002).
2. If you want to change the step timer timebase from 10 milliseconds to 1
second, or vice versa, do the following:
a. Press [F2] - Timebas.
b. Enter the new timebase.
3. If you have a PLC-5/250 and you want to change the port number:
a. Press [F3] - Port.
b. Enter the port number. The following table shows the port number to
enter for the specific link type.
Important: The port number is not selectable on these PLC-5 processors:
PLC-5/20
PLC-5/30
PLC-5/40
PLC-5/11
PLC-5/40L
PLC-5/60
PLC-5/60L
PLC–5/80