Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 30)

Chapter 3
Installing DDMC3 Installing DDMC32 Software
3-2
Finally, install your 6200 Series software on your PC (reference the PLC-5
Programming Software documentation, publication 6200-N8.001).
Once you have the software installed, you must configure the 1784-KT
address to correspond with the switch assembly setting.
For the 6180 Industrial Computer, set the 1784-KT address to 001011.
This address is a recommended station address only. If you have
conflicting hardware installed, you must find your own settings.
There are several DDMC32 disks in the installation disk set. To install
your DDMC32 software, follow the procedure below. At this point, we
assume that you have formatted your hard disk and installed Windows
NT
t.
1. Insert the first DDMC32 disk into the appropriate drive.
2. From the Start menu on the Windows NT Taskbar, choose Run... to
begin the DDMC32 setup program.
3. In the Run dialog box, enter the drive letter and name of the
DDMC32 setup program (e.g., A:\setup.exe).
4. Ensure the drive letter is correct and click on OK.
Setup will begin. Follow the instructions as they appear on the
screen.
Installing DDMC32 Software