Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 37)

Chapter 4
4-1
Configuring SDS Instructions
Read this chapter to learn about the SDS instruction and procedures that
describe programming and configuring the SDS instruction:
Important: You can use an SDS instruction in either the PLC-5 processor or
the PLC-5/250 processor. There are some minor differences in the
procedures for programming and configuring the instruction, depending on
which processor you are using. We note these differences where applicable.
Examples in this chapter are for the PLC-5 processor.
This chapter contains the following sections:
Section: Page:
Smart Directed Sequencer Overview 4-2
Programming the SDS Instruction 4-5
Documenting the SDS Instruction 4-18
Configuring the SDS Instruction 4-22
Exiting the SDS Instruction 4-31
Editing and Copying SDS Instructions 4-34
What to do Next 4-37
What this Chapter Contains