Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 27)

Chapter 2
Installing DDMC Hardware Components
2-3
ATTENTION: If you are using your DDMC32 software
(cat. no. 6404-DDMC) with a PLC-5/250 processor, you must
make certain that the Remote Scanner Module (cat. no.
5150-RS) has a daughterboard (cat. no. 5150-MRS) with a part
number of 960456-05 or later (For example, -05, - 06, -07, etc.).
You can locate this part number along the bottom edge of the
removable 5150-MRS daughterboard. Failure to observe this
caution could result in erroneous data appearing in the input
image table or internal storage table.
Contact your local Allen-Bradley support office or call Technical Support
at (216) 646-6800 to arrange for shipment of updated modules.
The procedure for installing DDMC32 components varies depending on
the operator interface terminal you use. We describe procedures for 6180
Industrial Computer on the following pages.
Using a 6180 Industrial Computer
The table below lists the general procedure for installing your DDMC32
hardware components when using a 6180 Industrial Computer. Refer to
the manuals listed for more detail.
Installing DDMC32
Components