Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 50)

Configuring SDS Instructions
Chapter 4
4-14
7. If you have a PLC-5/250 processor, type the Message Control Block
address and press
[ENTER].
The Message Control Block address must be entered in the following
manner:
0MSGX:X
where:
0 is the Resource Manager global memory (must be set to zero)
X:X
file number (0-9999)
message control block number (0-9999)
For example, 0MSG0:0 is a valid message control block address.
The I/O Definition screen is displayed (see below).
Entering or Modifying I/O Information
The inputs and outputs you enter into the I/O Defines on the I/O Definition
screen are used by each step in the SDS instruction. You can enter logical
addresses and symbols into the I/O Definition screen.
The following figure shows the screen you see if you are modifying I/O
information. (If you are entering new information, you have additional function
key options.)
Modify I/O Definition Screen (PLC-5/250)
Smart Directed Sequencer I/O Input Defines Output Defines
Definition for Control Block 0: I:001/16 0: O:000/04
N10:0 1: I:001/15 1: O:000/01
2: I:001/14 2: O:000/02
3: IS:003/02 3:
+=Ins Cmt==+ +=Adr Cmt==+ 4: IS:003/03 4:
|DRILL | |RETURNED L| 5: 5:
|MACHINE | |S | 6: 6:
|HEAD 1 | | | 7: 7:
| | | |
| | | |
+==========+ +==========+
Operator Interface Station Addr : 77
Timebase for Step Timer : 0.01
Port Number for Message : 2
Press a key to change a parameter or <ENTER> to accept parameters.
>
Program Forces:Disabled Data:Decimal Addr:Decimal PLC–5/250 Addr 5
Station Timebas Port Documnt Modify
Address IO Addr
F1 F2 F3 F5 F7