Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 41)

Configuring SDS Instructions
Chapter 4
4-5
Once you have determined where you want to apply the SDS instruction, you
can enter it into your ladder program and configure the instruction. Perform the
following tasks to program the SDS instruction:
download the SDS CAR
enter the SDS instruction
enter the configuration information
enter I/O information
To program the SDS instruction into your ladder program:
1. Access the PLC-5 or PLC-5/250 Programming Software main menu,
shown below, from the Allen-Bradley main menu interface.
Programming Software Main Menu (PLC-5)
+========================= PLC–5 PROGRAMMING SOFTWARE =========================+
| |
| A 6200 Series Software Product |
| |
| Copyright 1986, 1987, 1988, 1989, 1990, 1991, Allen–Bradley Company, Inc. |
| All Rights Reserved |
| |
| Release 4.3 |
| |
| This software is licensed to: Company Allen–Bradley Co. |
| Location 747 Alpha Drive |
| PSP Engineering |
| Serial Number: ZZ0AA0PP |
+==============================================================================+
| Fri June 14, 1991 9:39:09 am |
+––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––+
| Terminal Address: 77 Current Device: 1784–KT (DH+) PLC Address: 1 |
+==============================================================================+
Press a function key
Online Online Offline Offline Who Sftware File Reports Compare Exit
Program Configr Program Configr Configr Utils System
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
Programming the SDS
Instruction