Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 29)

Chapter 3
3-1
Installing DDMC32 Software
Read this chapter to learn how to install your DDMC32 software. To
install your software, you perform the following tasks:
set up your operator interface terminal
install 6200 Series software
install DDMC32 Monitoring Software
This chapter contains the following sections:
Section: Page:
Setting Up Your Operator Interface Terminal 3-1
Installing and Configuring the Software 3-1
Installing DDMC32 Software 3-2
Completing the DDMC32 Software Installation 3-8
What to do Next 3-8
Before you install your DDMC32 software, you must power up the 6180
Industrial Computer or your PC with 6200 Series software (v. 4.5 or later),
Microsoft Windows NT
t 4.0, and RS Linx (v. 1.70.62 or later).
Using a 6180 Industrial Computer
To power up the 6180 computer, turn the system power switch on the rear
of the computer to the ON position. The system performs a series of
self-tests to determine if its components are properly installed and
operating. You do not have to change the 6180 setup information to run
the DDMC32 software.
Install and configure Windows NT
t on your PC according to your product
information.
Next, install and configure RSLinx on your operator interface terminal
(refer to the Rockwell Software Installation Guide for Windows-based
products for further information).
What this Chapter Contains
Setting Up Your Operator
Interface Terminal
Installing and Configuring the
Software