Rockwell Automation D64046.5.1 U MNL WIN DDMC - Manual (Page 84)

Chapter 5
Configuring DFA Instructions
5-10
Display the Documentation screen for the
DFA instruction. [F5] - Documnt
Modify an input address at the cursored
location. [F7] - Modify Inputs
Insert an input address at the cursored
location
1
[F8] – Insert Inputs
Delete an input address at the cursored
location
1
[F9] – Delete Inputs
Remove an input address at the cursored
location
1
[F10] – Remove Inputs
1 These function keys do not appear on the screen if you are modifying the instruction.
To insert or modify information in the Input Definition screen, follow the
procedure below.
1. If you want to change the Operator Interface Station Address:
a. Press [F1] - Station Address
b. Type the number of the Data Highway Plus node ( 0-77
8
) where
you want the diagnostic message sent, for example 77 , and
press [ENTER].
Important: If you want to send diagnostic messages to other operator
interface stations, use the Message Instruction in 6200 Series software.
For procedures on sending messages with the Message Instruction, refer to
PLC-5 Programming Software Documentation Set (publication
9399-PL5MAN) or the PLC-5/250 Programming Software Documentation
Set (publication 9313-5250).
2. If you have a PLC-5/250 and you want to change the port number,
your screen has an additional option:
a. Press [F3] - Port.
b. Enter the port number. The following table shows the port
number to enter for the specific link type.
Port Number Entries
For this link: Enter this port number:
ASCII, DF1, Master, and Slave 1
port 2A, 2B for DH and DH+ 2
port 3 for DH and DH+ 3