Rockwell Automation 2093-xxxx Kinetix 2000 Multi-axis Servo Drive User Manual - Manual (Page 101)

Publication 2093-UM001A-EN-P — January 2007
Connecting the Kinetix 2000 Drive System 101
In this example, the second Kinetix 2000 system is located in a separate
cabinet and connected with bulkhead adapters.
Fiber-optic Cable Example 4 (bulkhead adapters)
SERCOS Cables
The Kinetix 2000 supports the SERCOS fiber optic cables listed in the table.
Refer to the Fiber-optic Cable Installation and Handling Instructions,
publication 2090-IN010, for additional information.
IMPORTANT
To avoid signal loss, do not use bulkhead adapters to connect glass
cables. Use bulkhead adapters only for plastic-to-plastic cable
connections.
SERCOS in t erface TM
Tx (rear) Rx (front)
OK CP
SERCOS Ring
ControlLogix Chassis
1756-M08SE SERCOS
Interface Module
Kinetix 2000 System
(2093-PRS5 power rail)
SERCOS Fiber Optic
Bulkhead Adapter
SERCOS Fiber-Optic Ring
Receive
Receive
Transmit
SERCOS Fiber Optic
Bulkhead Adapter
Kinetix 2000 System
(2093-PRS5 power rail)
Transmit
Receive Transmit
SERCOS Cable Selection for Kinetix 2000 Drives
Connection Adjacent Connection
(module to the right)
Catalog Number of
SERCOS Cable
(1)
2093-AC05-MP1
2093-AC05-MP2
2093-AC05-MP5 2093-AMP1
2093-AMP2
2093-AMP5
2090-SCEP0-1 series B
2093-AC05-MP1
2093-AC05-MP2
2093-AC05-MP5
2093-AM01
2093-AM02
2090-SCEP0-2
2093-AMP1
2093-AMP2
2093-AMP5 2093-AMP1
2093-AMP2
2093-AMP5
2090-SCEP0-1 series B