Rockwell Automation 2093-xxxx Kinetix 2000 Multi-axis Servo Drive User Manual - Manual (Page 41)

Publication 2093-UM001A-EN-P — March 2007
Mounting the Kinetix 2000 Drive System 41
The module is fully seated when each locking clip snaps into the
bottom of the power rail, and the locking screw boss is flush at the
top of the power rail.
3. Torque mounting screws to 0.7 Nm (6 lb-in.).
4. Determine if you have additional modules to mount .
Mounting the Line Interface
Module Your Kinetix 2000 drive requires an external power source. To meet EU EMC
requirements, this requires you to install a line interface module or similar
discrete components (ac line filter, contactor, fusing, and transformers) that
properly condition and control the input power.
Refer to Connecting the Kinetix 2000 Drive System on page 61 and the
Interconnect Diagrams on page 37 for information about this specific
installation.
Top front view of
single-wide AM,
SM, or SF
(2093-AMPx is shown)
Locking screws
Top front view of
double-wide AM
(2093-AM0x shown)
Locking clips (not
visible)
on bottom of
each module.
Top front view of
IAM
(2093-AC05-MPx)
IMPORTANT
There is one mounting screw on any Kinetix 2000 module (IAM, AM,
SM, or SF).
If You Then
Have additional modules to mount
Return to step 1 and complete installation of
your next AM, SM, or SF module.
Do not have additional modules to mount Go To Mounting the Line Interface Module.