Rockwell Automation SA3100 Distributed Power System Drv Config,Program - Manual (Page 159)

Index Index-3
feedback data (vector), 2-12
Flex I/O, 2-24
meter port selection (V/Hz), 2-22
meter port selection (vector), 2-14
motor data (vector), 2-6, 2-9
power module data (V/Hz), 2-16
power module data (vector), 2-5
V/Hz characteristic, 2-20
Service manual cross reference, 1-2 to 1-4
Sug. Var. Name, 3-3
T
Torque overload ratio parameter precautions, G-1
U
UDC Error Code, 3-3
UDC module
adding, 2-1 to 2-2
initiate change in setup register, 3-56
meter port setup registers, 3-55 to 3-60
test I/O registers, 3-53 to 3-60
test switch inputs register, 3-53 to 3-54
UDC task scan, 3-50, 4-2
UDC/PMI communication status registers, 3-11 to
3-18
PMI communication status, 3-14 to 3-17
PMI CRC error count, 3-17
PMI format error count, 3-17
PMI receive count, 3-17
UDC communication status, 3-11 to 3-13
UDC CRC error count, 3-14
UDC fiber-optic link status, 3-18
UDC format error count, 3-14
UDC receive count, 3-13
UDC transmitted message count, 3-18
V
Variable configurator, 3-1
Vector with constant power regulator
block diagram, D-2
configuring, 2-5 to 2-15
control algorithm, D-1 to D-2
parameter entry example, I-1
register reference, A-1 to A-2
Viewing registers, 3-1 to 3-2
application registers, 3-2
command registers, 3-2
feedback registers, 3-2
interrupt status and control registers, 3-2
Port 0 Flex I/O, 3-1
UDC module test I/O register, 3-2
Volts per hertz regulator
block diagram, E-3
configuring, 2-16 to 2-23
constant torque curve, E-4
control algorithm, E-1 to E-4
register reference, B-1 to B-2
variable torque 7-point curve, E-4
W
Warnings, 3-36 to 3-39