Rockwell Automation SA3100 Distributed Power System Drv Config,Program User Manual
Page 54
3-16
SA3100 Drive Configuration and Programming
PMI Communication Status Register (Continued)
84/1084
Multiplexed Data Verification Failure
Bit 9
The Multiplexed Data Verification Failure bit
is set if data multiplexed into
command/feedback messages does not
verify.
Hex Value:
0200H
Sug. Var. Name:
N/A
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Invalid PMI Start Operating System Address
Bit 12
The Invalid PMI Start Operating System
Address bit is set by the PMI if the operating
system is not within the allocated operating
system address area.
Hex Value:
1000H
Sug. Var. Name:
N/A
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
This condition will cause the loading of the PMI operating system to fail. However,
the UDC module and the PMI will continue to retry loading the PMI operating
system.
Insufficient PMI Memory to Load the PMI Operating System
Bit 13
The Insufficient PMI Memory to Load the
PMI Operating System bit is set by the PMI
if there is insufficient memory for loading the
operating system.
Hex Value:
2000H
Sug. Var. Name:
N/A
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
This condition will cause the loading of the PMI operating system to fail. However,
the UDC module and the PMI will continue to retry loading the PMI operating
system.
Invalid PMI Load Address
Bit 14
The Invalid PMI Load Address bit is set by
the PMI if the address at which it is to load
the operating system is invalid.
Hex Value:
4000H
Sug. Var. Name:
N/A
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
This condition will cause the loading of the PMI operating system to fail. However,
the UDC module and the PMI will continue to retry loading the PMI operating
system.