Dell PowerEdge VRTX - Manual (Page 110)

110
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
router from the list. The switch supports one static IPv6 default router.
Dynamic default routers are routers that have sent router advertisements to
the switch IPv6 interface.
When adding or deleting IP addresses, the following events occur:
• When removing an IP interface, all of its default gateway IP addresses are
removed.
• Dynamic IP addresses cannot be removed.
• An alert message is displayed after a user attempts to insert more than one
IP address.
• An alert message is displayed when attempting to insert a non-Link Local
type address.
To configure a router:
1 Click System > IP Addressing > IPv6 Default Gateway in the tree view to
display the IPv6 Default Gateway: Summary page.
The previously-defined routers are displayed with the following fields:
–
IPv6 Default IPv6 Address — The router’s address.
– Interface — The interface on which the router is accessed.
– Type — The means by which the default gateway was configured. The
possible options are:
•
Static — The default gateway is user-defined.
• Dynamic — The default gateway is dynamically configured
through router advertisement.
– State — The router’s status. The possible options are:
•
Incomplete — Address resolution is in progress and the link-layer
address of the default gateway has not yet been determined.
• Reachable — The default gateway is known to have been
reachable recently (within tens of seconds ago).
• Stale — The default gateway is no longer known to be reachable
but until traffic is sent to the default gateway, no attempt is made
to verify its reachability.