Dell PowerEdge VRTX - Manual (Page 198)

198
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
Uploading Files Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the File Upload page.
The following is an example of the CLI commands:
Active Images
There are two firmware images, Image1 and Image2, stored on the switch.
One of these images is identified as the active image, and the other is
identified as the inactive image. The switch boots from the active image.
You can switch the inactive image to the active image, and then reboot the
switch.
To select the image file to be used after reset:
1 Click System > File Management > Active Images in the tree view to
display the Active Images page.
The following fields are displayed:
–
Active Image — The IP address of the image file that is currently
active on the device.
– After Reset — Select one of the possible IP addresses of the image to
be active after reset. The possible options are:
2 Click Apply to select the image file to be used after reset in After Reset.
Table 6-55. File Upload CLI Commands
CLI Command Description
copy source-url destination-url
Copies any file from a source to a
destination.
console# copy image tftp://10.6.6.64/uploaded.ros
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Copy: 4234656 bytes copied in 00:00:33 [hh:mm:ss]
01-Jan-2000 07:30:42 %COPY-W-TRAP:
The copy operation was completed successfully