Dell PowerEdge VRTX - Manual (Page 219)

219
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_NetworkSecurity.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
– Protocol Select from List — Select to create an ACE, based on a
specific protocol. The following options are available:
• ICMP — Internet Control Message Protocol (ICMP). The ICMP
allows the gateway or destination host to communicate with the
source host. For example, to report a processing error.
• TCP — Transmission Control Protocol (TCP). Enables two hosts
to communicate and exchange data streams. TCP guarantees
packet delivery, and guarantees packets are transmitted and
received in the order the are sent.
• UDP — User Datagram Protocol (UDP). Communication
protocol that transmits packets but does not guarantee their
delivery.
• IPV6 — Matches the packet to the IPV6 protocol.
– Protocol ID To Match — Enter a protocol.
– Source Port — Enter the TCP/UDP source port. Enter either a Single,
Range or select Any to include all ports.
– Destination Port — Enter the TCP/UDP destination port. Enter
either a Single, Range or select Any to include all ports.
– TCP Flags — To use TCP flags, check the TCP Flag checkbox and
then check the desired flag(s).
– ICMP — Specifies an ICMP message type for filtering ICMP packets.
This field is available only when ICMP is selected in the Protocol
field. The following options are available:
•
Select from List — Select an ICMP type from the list.
• ICMP Type — Enter the ICMP type.
• Any — Check to use all ICMP types.
– ICMP Code — Specifies an ICMP message code for filtering ICMP
packets that are filtered by ICMP message type or ICMP message
code. This field is available only when ICMP is selected in the
Protocol field. The following options are available:
•
ICMP Code — Enter an ICMP code.
• Any — Check to use all ICMP codes.