Dell PowerEdge VRTX - Manual (Page 369)

369
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_LLDP.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
– VLAN ID — Enter the VLAN ID to which the traffic should be sent.
– VLAN Type —Select whether the traffic is Tagged or Untagged.
– User Priority — Select the traffic priority assigned to the network
application.
– DSCP Value — Select the value to be used by neighbors to mark the
traffic sent to the switch.
Configuring MED Network Policies Using CLI Commands
The following commands are used to configure MED network policies.
The following is an example of the CLI commands:
MED Port Settings
To assign MED network policies to ports:
1 Click Switching > LLDP > MED Port Settings in the tree view to display
the MED Port Settings: Summary page.
2 All ports are displayed along with the following fields:
– LLDP MED Status — Specifies if LLDP-MED is enabled on the
selected port.
– Network Policy — Specifies whether a network policy is assigned to
the port.
– Location — Specifies whether the location is advertised.
– PoE — Specifies whether PoE is enabled on the port
Table 15-3. LLDP MED Network Policies CLI Commands
CLI Command Description
lldp med network-policy number
application [vlan vlan-id ] [ vlan-
type { tagged | untagged }] [ up
priority ][ dscp value ]
no lldp med network-policy number
Defines an LLDP MED network
policy.
Use the no form of this command
to remove an LLDP MED
network policy.
console(config)# lldp med network-policy 1 voice-
signaling vlan 1