Dell PowerEdge VRTX - Manual (Page 273)

273
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_Ports.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
The following is an example of the CLI commands:
Port Mirroring
Switches usually only forward frames to relevant ports. To monitor traffic,
either for information gathering, such as statistical analysis, or for
troubleshooting higher-layer protocol operation, the Mirroring feature
forwards frames to a monitoring port.
Mirroring provides the ability to specify that a desired destination (target)
port will receive a copy of all traffic passing through designated source ports.
The frames arriving at the destination port are copies of the frames passing
through the source port at ingress, prior to any switch action.
storm-control broadcast enable
no storm-control broadcast
enable
Enables Broadcast storm control.
Use the no form of this command to
disable Broadcast storm control.
storm-control broadcast level
kbps kbps
no storm-control broadcast
level
Configures the maximum Broadcast
rate.
Use the no form of this command to
return the Broadcast level to the default
value.
show storm-control
[interface-id | detailed]
Displays the storm control
configuration.
console(config)# interface gi0/1
console(config-if)# storm-control broadcast enable
console(config-if)# storm-control include-multicast
unknown-unicast
console# show storm-control gi0/1
Port State Rate [Kbits/Sec] Included
-------- -------- ---------------- ---------------------
gi0/1 Disabled 8500 Broadcast
Table 8-10. Storm Control CLI Commands (Continued)
CLI Command Description