Lldp fcoe-priority-bits – Dell POWEREDGE M1000E User Manual
Page 124
Advertising
108
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
lldp fcoe-priority-bits
6
lldp fcoe-priority-bits
Sets the priorities on which FCoE traffic will be allowed.
Synopsis
lldp fcoe-priority-bits value
no lldp fcoe-priority-bits
Operands
value
Specifies the bitmap value. The range of valid values is 0 to 15.
Defaults
The default value is 8.
Command
Modes
Interface configuration mode
Description
Use this command to set the priorities on which FCoE traffic will be allowed. The no lldp
fcoe-priority-bits command returns to the default setting.
Usage
Guidelines
There are no usage guidelines for this command.
Examples
To set the priorities on which FCoE traffic will be allowed:
switch(conf-if-te-0/1)#lldp fcoe-priority-bits 15
See Also
protocol lldp
Advertising