Switchport converged – Dell POWEREDGE M1000E User Manual

Page 69

Advertising

Dell Converged Enhanced Ethernet Command Reference

53-1002115-01

switchport converged

Adds or removes native and tagged VLANs on a Layer 2 interface.

Synopsis

switchport converged {vlan vlan_id | allowed vlan {add vlan_id | all | except vlan_id | none |
remove vlan_id}}

no switchport converged

Operands

vlan vlan_id

Sets the default native VLAN for the Layer 2 interface.

allowed vlan

Sets the VLANs that will transmit and receive through the Layer 2 interface.

add vlan_id

Adds a VLAN to transmit and receive through the Layer2 interface. The range
of valid values is 2-3583.

all

Allows all VLANs to transmit and receive through the Layer 2 interface.

except vlan_id

Allows all VLANs except the VLAN ID to transmit and receive through the Layer
2 interface. The range of valid values is 2-3583.

none

Allows no VLANs to transmit and receive through the Layer 2 interface.

remove vlan_id Removes a VLAN that transmits and receives through the Layer 2 interface.

The range of valid values is 2-3583.

Defaults

The default native VLAN for a converged interface is 1.

Command

Modes

Interface configuration mode

Description

Use this command to add or remove tagged VLANs on a Layer 2 interface.

Usage

Guidelines

There are no usage guidelines for this command.

Examples

To set the native VLAN of 200 on an interface:

switch(conf-if-te-0/19)#switchport converged vlan 200

To set the tagged VLAN on an interface to 100:

switch(conf-if-te-0/19)#switchport converged allowed vlan add 100

To remove the tagged VLAN 100 from the interface:

switch(conf-if-te-0/19)#switchport converged allowed vlan remove 100