Dell POWEREDGE M1000E - Manual (Page 18)

2 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
CLI command modes
1
TABLE 2 Accessing the CEE CLI command modes
Command
mode Prompt How to access the command mode Description
EXEC switch> Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user. Display running system information
and set terminal line parameters.
Privileged
EXEC switch# From the EXEC mode, enter the
enable command. This is the administrative mode
which also includes EXEC mode
commands and allows you to display
and change system parameters.
Global
configuration switch(config)# From the EXEC mode, enter the
configure terminal EXEC command. Configure features that affect the
entire switch.
Interface
configuration Port-channel:
switch (conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch (conf-if-te-0/1)#
VLAN:
switch (conf-if-vl-1)#
From the global configuration mode,
specify an interface by entering one
of the following interface types:
•
interface port-channel
•
interface
•
interface vlan
Access and configure individual
interfaces.
Protocol
configuration LLDP:
switch (conf-lldp)#
Spanning-tree:
switch (conf-mstp)#
switch (conf-rstp)#
switch (conf-stp)#
From the global configuration mode,
specify a protocol by entering one of
the following protocol types:
•
protocol lldp
•
protocol spanning-tree mstp
•
protocol spanning-tree rstp
•
protocol spanning-tree stp
Access and configure protocols.
Console and
VTY (line)
configuration switch (config-line)# From the global configuration mode,
configure a terminal connected
through the console port by entering
the line console command.
Configure a terminal connected
through a Telnet session by entering
the line vty command. Configure a terminal connected
through the console port or a
terminal connected through a Telnet
session.
Feature
configuration CEE map:
switch (config-ceemap)#
FCoE map:
switch (config-fcoe-map)#
Standard ACL:
switch (conf-macl-std)#
Extended ACL:
switch (conf-macl-ext)#
Port Mirror:
switch(config-mon-sess-1
From the global configuration mode,
specify a feature by entering one of
the following feature names:
•
cee-map
•
fcoe-map
•
mac access-list
•
monitor session
Access and configure CEE, FCoE,
Port Mirroring, and ACL features.