Dell POWEREDGE M1000E - Manual (Page 171)

Dell Converged Enhanced Ethernet Command Reference 155
53-1002115-01
show mac access-group
10
show mac access-group
Displays the current MAC ACL mapping to interfaces.
Synopsis show mac access-group [interface port-channel number | {in | ex}tengigabitethernet slot/port |
vlan vlan_id]
Operands interface Specifies the interface for which to display the MAC ACL mapping.
port-channel number
Specifies the port-channel number. The range of valid values is 1–63.
extengigabitethernet
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
intengigabitethernet
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
vlan vlan_id Specifies the VLAN number. The range of valid values is 1-3583.
Defaults There are no default configurations for this command.
Command
Modes
EXEC mode
Description Use this command to display the current MAC ACL mapping to interfaces.
Usage
Guidelines
If you do not specify an interface, this command shows the mapping of MAC ACL to all interfaces.
Examples To display the current MAC ACL mapping for 10 Gbps Ethernet interface 0/1:
switch#show mac access-group interface intengigabitethernet 0/1
Interface Te 0/1
Inbound access-list is std_acl
To display the current MAC ACL mapping for interface VLAN 100:
switch#show mac access-group interface vlan 100
Interface Vl 100
Inbound access-list is ext_acl
To display the current MAC ACL mapping for 10 Gbps Ethernet interface 0/7 where there is no ACL
applied:
switch#show mac access-group interface intengigabitethernet 0/7
Interface Te 0/7
Inbound access-list is not set
See Also show running-config, show statistics