Qos commands, Chapter 16, Chapter 16, “qos commands – Dell POWEREDGE M1000E User Manual
Page 255: Chapter
Dell Converged Enhanced Ethernet Command Reference
239
53-1002115-01
Chapter
16
QoS Commands
cee
Applies a CEE Provisioning map on an interface.
Synopsis
cee default
no cee
Operands
default
Only a single map name, called default, is allowed.
Defaults
There is no CEE Provisioning applied on an interface.
Command
Modes
Interface configuration mode
Description
Use this command to apply the CEE map on an interface. Use the no cee command to remove the
CEE Provisioning map.
Usage
Guidelines
The CEE map applied on an interface should exist on the switch.
Examples
To apply the CEE map on an interface:
switch(conf-if-te-0/1)#cee default
Because the switch does not allow applying a CEE map that does not exist, the following error
displays:
switch(conf-if-te-0/1)#cee test
% Error: Map does not exist
See Also
cee-map