Show statistics access-list mac – Dell POWEREDGE M1000E User Manual

Page 172

Advertising

156

Dell Converged Enhanced Ethernet Command Reference

53-1002115-01

show statistics access-list mac

Shows active ACL rules in the switch and if the rules have counters enabled.

Synopsis

show statistics access-list mac name [interface port-channel number | {in | ex}tengigabitethernet
slot/port | vlan vlan_id]

Operands

name

Specifies a unique name for the MAC ACL.

interface

Specifies the interface for which to display the statistics.

port-channel number

Specifies the port-channel number. The range of valid values is 1–63.

tengigabitethernet

Specifies a valid 10 Gbps Ethernet interface.

slot

Specifies a valid slot number.

port

Specifies a valid port number.

vlan vlan_idSpecifies the VLAN number. The range of valid values is 1-3583.

Defaults

There are no default configurations for this command.

Command

Modes

EXEC mode

Description

Use this command to display the active rules on the switch and whether those rules have counters
enabled.

Examples

To display the statistics for standard and extended MAC ACL applied on two interfaces
intengigabitethernet 0/1 and VLAN 100:

switch#show statistics access-list mac std_acl

mac access-list standard std_acl on interface Te 0/1

seq 10 deny 0011.2222.3333 count (6312 frames)

seq 20 deny 0011.2222.4444 count (20 frames)

seq 30 deny 0011.2222.5555

seq 40 deny 0011.2222.6666 count (100000 frames)

switch#show statistics access-list mac ext_acl

mac access-list extended ext_acl on interface Vl 100

seq 10 deny 0011.2222.2222 0022.2222.2222 ipv4 count (4350 frames)

seq 20 deny 0011.2222.2222 0022.2222.2222 fcoe count (0 frames)

seq 30 deny 0011.2222.2222 0022.2222.2222 arp

seq 40 deny 0011.2222.2222 0022.2222.2222 10000 count (560 frames)

If the rule is not written into the hardware the output displays as shown below:

seq 8 permit 00c0.e000.0080 count (unwritten)

If the rule is written into the hardware, but the counters are not enabled for that rule, the output
displays as shown below:

seq 9 permit 00c0.e000.0090 count (uncounted)