Dell POWEREDGE M1000E - Manual (Page 271)

Dell Converged Enhanced Ethernet Command Reference 255
53-1002115-01
qos rcv-queue multicast threshold
16
qos rcv-queue multicast threshold
Configures a cap on the maximum queue depth for multicast packet expansion queues.
Synopsis qos rcv-queue multicast threshold mTC0 mTC1 mTC2 mTC3 mTC4 mTC5 mTC6 mTC7
no qos rcv-queue multicast threshold
Operands mTC0 Sets the Tail Drop Threshold for multicast Traffic Class 0 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC1 Sets the Tail Drop Threshold for multicast Traffic Class 1 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC2 Sets the Tail Drop Threshold for multicast Traffic Class 2 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC3 Sets the Tail Drop Threshold for multicast Traffic Class 3 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC4 Sets the Tail Drop Threshold for multicast Traffic Class 4 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC5 Sets the Tail Drop Threshold for multicast Traffic Class 5 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC6 Sets the Tail Drop Threshold for multicast Traffic Class 6 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
mTC7 Sets the Tail Drop Threshold for multicast Traffic Class 7 packet expansion
queue in units of packets (pkt). The range of valid values is 0-16383 packets.
.Defaults The default is 64 packets for each multicast Traffic Class.
Command
Modes
Global configuration mode
Description Use this command to configure a cap on the maximum queue depth for multicast packet expansion
queues. The individual Tail Drop Threshold is specified for each of the four multicast traffic classes.
These Tail Drop Thresholds are applied uniformly across the entire system. These queue depths are
enforced independently by each switch. Use the no qos rcv-queue multicast threshold command to
return the multicast expansion queques to the default value.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To increase multicast packet expansion Tail Drop Threshold to 1000pkt for each multicast Traffic
Class:
switch(config)#qos rcv-queue multicast threshold 1000 1000 1000 1000 1000 1000
1000 1000
To return the system to the default multicast packet expansion Tail Drop Threshold value:
switch(config)#no qos rcv-queue multicast threshold
See Also qos rcv-queue multicast