Deny (standard acls) – Dell POWEREDGE M1000E User Manual

Page 160

Advertising

144

Dell Converged Enhanced Ethernet Command Reference

53-1002115-01

deny (standard ACLs)

Configures a MAC address rule to drop traffic based on the source MAC address.

Synopsis

deny {MAC_ACL | any} [count]

no deny {MAC_ACL | any}

Operands

MAC_ACL

Specifies the source host MAC address for which to set deny conditions. Use
the format HHHH.HHHH.HHHH.

any

Specifies any source MAC address.

count

Enables counting of the packets matching the rule.

Defaults

By default, no MAC ACLs are configured.

Command

Modes

Feature Access Control List Configuration mode

Description

Use this command to configure rules to match and to drop traffic based on the source MAC
address. You can also enable counters for a specific rule. There are 255 ACL counters supported
per port group. Use the no deny command to remove a rule from the MAC ACL.

Usage

Guidelines

There are no usage guidelines for this command.

Example

To create a rule in a MAC standard ACL to drop traffic from the source MAC address

0022.3333.4444

and to enable the counting of packets:

switch(conf-macl-std)#deny 0022.3333.4444 count

To delete a rule from a MAC standard ACL:

switch(conf-macl-std)#no deny 0022.3333.4444