Switchport trunk – Dell POWEREDGE M1000E User Manual
Page 71
Dell Converged Enhanced Ethernet Command Reference
55
53-1002115-01
switchport trunk
3
switchport trunk
Adds or removes tagged VLANs on a Layer 2 interface.
Synopsis
switchport trunk allowed vlan {add vlan_id | all | except vlan_id | none | remove vlan_id}
no switchport trunk
Operands
allowed vlan
Sets the VLANs that will transmit and receive through the Layer 2 interface.
add vlan_id
Adds a VLAN to transmit and receive through the Layer2 interface. The range
of valid values is 2-3583.
all
Allows all VLANs to transmit and receive through the Layer 2 interface.
except vlan_id
Allows all VLANs except the VLAN ID to transmit and receive through the Layer
2 interface. The range of valid values is 2-3583.
none
Allows no VLANs to transmit and receive through the Layer 2 interface.
remove vlan_id
Removes a VLAN that transmits and receives through the Layer 2 interface.
The range of valid values is 2-3583.
Defaults
There are no default configurations for this command.
Command
Modes
Interface configuration mode
Description
Use this command to add or remove tagged VLANs on a Layer 2 interface.
Usage
Guidelines
There are no usage guidelines for this command.
Examples
To set the tagged VLAN on an interface to 100:
switch(conf-if-te-0/19)#switchport truck allowed vlan add 100
To remove the tagged VLAN 100 from the interface:
switch(conf-if-te-0/19)#switchport truck allowed vlan remove 100
See Also
show vlan brief, show interface switchport, switchport mode, switchport trunk