Multiplier – Dell POWEREDGE M1000E User Manual
Page 127
Advertising
Dell Converged Enhanced Ethernet Command Reference
111
53-1002115-01
multiplier
6
multiplier
Sets the number of consecutive misses of hello messages before LLDP declares the neighbor as
dead.
Synopsis
multiplier value
no multiplier
Operands
value
Specifies a multiplier value to use. The range of valid values is 1-10.
Defaults
The default multiplier value is 4.
Command
Modes
Protocol LLDP configuration mode
Description
Use this command to set the number of consecutive misses of hello messages before LLDP
declares the neighbor as dead. Use the no multiplier command to return to the default setting.
Usage
Guidelines
There are no usage guidelines for this command.
Examples
To set the number of consecutive misses:
switch(conf-lldp)#multiplier 2
See Also
hello
Advertising