Leica Geosystems Leica 3D Disto - Manual User Manual
Page 122
3D Disto, Software Applications
122
Relocation
step-by-step
This feature allows the relocation of the 3D Disto into a defined coordinate system
previously established by the Secure Location procedure, for example to complete
a previous measurement.
1. Press Menu » Applications » Location » Relocation.
3. If there are no Secure Points in the memory, pop-up prompts Not enough
Secure Points in the memory.
Use a 3D Disto position that allows targeting and measuring at least three
Secure Points around your working area.
2. A pop-up prompts you to define the tolerance.
Press OK to confirm the value.
A lower tolerance increases the accuracy of
your measurements and requires precise
aiming and visibility of the Secure Points.
If there are no Secure Points available but your measurement must fit
to the geometry of a previous one, just start your measurement with
the same Base Line points. These are the first two points of a meas-
urement.