Leica Geosystems Leica 3D Disto - Manual - Manual (Page 174)

3D Disto, Check & Adjust 174
Adjustment
step-by-step 1. Calibration is started in Menu » Device » Calibration.
2. Press .
3. Viewfinder opens. Place a target mark at a distance > 25 m. Now aim at the
target mark as precisely as possible. Press when the red laser spot is
exactly on the target.
4. Viewfinder stays open and red crosshairs are displayed. Move crosshairs to the
centre of target mark as precisely as possible with the arrow keys. Press
again.
5. If in tolerance, pop-up appears with Set new: x=...px; y=...px, Reset to factory
default, or Cancel calibration.
6. Choose Set... or Reset... to adjust crosshairs. Final pop-up asks Are you sure?
Yes/Cancel.
7. If Yes, checkmark is displayed to confirm parameters were set successfully.