8 error messages, Error messages, 8error messages – Leica Geosystems Leica 3D Disto - Manual User Manual
Page 168
3D Disto, Error Messages
168
8
Error Messages
Error messages and
advice
Error no.
Advice
150
Working range was exceeded.
151
Invalid measurement.
152
Change 3D Disto's position or use ruler for offset points.
160
Repeat and do not move the ruler between both measurements.
161
In some cases the Offset Point tool can not be used.
170
Restart 3D Disto if the problem persists.
171
Check all devices, for example power supply or cables, and try again.
240
Tilt sensor calibration was not successful. System accuracy is at risk.
Contact your distributor or Leica Geosystems representative.
241
Too much drift. Repeat calibration precisely.
243
Set up instrument stably. Do not touch or rotate the 3D Disto. Repeat
calibration.
300
Select a horizontal line.
350
Check projection surface. Laser could not reach the correct position.