Leica Geosystems Leica 3D Disto - Manual - Manual (Page 63)

63 3D Disto, Instrument Setup
To work with a cable connection to 3D Disto plug in USB cable and press .
To work with WLAN press . If connection failed, connect via USB cable as
described above and change the WLAN channel in Menu » Device » WLAN
channel. Then retry WLAN connection in Menu » Device » Connect 3D Disto.
To transfer data to or from a PC connect the Control Unit to PC with USB cable
and press . Refer to "5.4.4 Data Transfer" for more information.

It is recommended to plug in the USB cable before turning on the
3D Disto, otherwise the instrument starts self-levelling procedure
again if moved.

Do not extend the USB cable with an adapter and only use the
Leica Geosystems cable delivered in the container.

Change the WLAN channel if the connection is instable.