Leica Geosystems Leica 3D Disto - Manual - Manual (Page 57)

57 3D Disto, User Interface
4.2 RM100 Remote Control
Description The RM100 Remote Control (IR) has five buttons that allow turning the 3D Disto and
executing a distance measurement or point projection, depending on the application
program running.

The RM100 Remote Control does not support the Tool Kit applications.
Targeting
procedure 1. Rough targeting: hold / / / to turn the 3D Disto as long as key is
pressed.
2. Fine targeting: short tap on / / / to turn the 3D Disto by small
single steps.
3. Measure: Press .

The red LED at the top of the RM100 Remote Control will flash each time a button is
pressed, indicating the remote is transmitting to the 3D Disto.