Leica Geosystems Leica 3D Disto - Manual - Manual (Page 41)

41 3D Disto, Description of the System
Demo mode The available application programs can be tested by activating the Demo mode. This
provides full software performance for 40 working hours. A pop-up reminds the user
when the Demo mode expires.
To enable the application programs in Demo mode, carry out the following steps:
1. Press Menu » Applications » Demo.
2. All application programs are listed in the Menu and marked with until Demo
mode runs out.
Customised
application
programs Customised software, specific to user requirements, can be developed using the
third-party software development environment. Further information is available on
request from a Leica Geosystems representative.