Leica Geosystems Leica 3D Disto - Manual User Manual
Page 124
3D Disto, Software Applications
124
8. If Yes: Folder opens to choose next Secure Point. Proceed as described in 4. to
7. for 2
nd
and 3
rd
point.
9. When you have measured three points successfully a pop-up shows OK.
Measure more Secure Points? Yes/No/Cancel.
10. Press Yes to continue and proceed as described in 4. to 7.
11. Press No to finish. If successful, a pop-up displays the dimensions between old
and new position: XXXm; Height: XXXm; OK/Cancel. Accept with OK or Cancel
to measure further points.
12. If Relocation was not successful, pop-up prompts Out of tolerance! Measure
more Secure Points? Yes/No/Cancel. Go on as described in 4. to 11.
13. Press
to close the application.
If the first two Secure Points were measured successfully the 3D Disto
roughly turns to the next chosen Secure Point. You just have to do the
fine targeting and press
.